Table of Contents
Advertisement
1
D-Series Camera Installation
1.5
The camera can be powered with a conventional 24 Vac/Vdc power supply:
21 Vac to 30 Vac, or
21 Vdc to 30 Vdc.
The D-Series Camera produces analog or digital (IP) video output (or both). Analog video will require
at least one connection to a video monitor or an analog video matrix switch. In most analog
installations, two video connections will be used—one for the thermal camera video, and one for the
daylight camera video. The camera pigtail provides two BNC connectors for these video channels.
An Ethernet connection is provided for IP video streaming and for command and control
communications (pan/tilt/zoom/etc.). A PC or laptop with a web browser is also required for camera
configuration and maintenance (software/firmware updates).
For analog installations that are not using Ethernet/IP, a serial cable (RS232 or RS422) can optionally
be connected and used for command and control communications, supporting either Pelco D or Bosch
protocols. In installations using analog video and serial communications, it is recommended an
Ethernet cable is installed for camera configuration and troubleshooting using a PC with a web
browser.
For installations where the camera is mounted on a tower or pole or other location that may be difficult
to access, it is recommended the Ethernet connection should be installed from the camera down to
ground level at a minimum, to allow easier access.
1.5.1
The D-Series camera package includes these standard components:
•
Multi-sensor Pan/Tilt Camera Gimbal Assembly
•
Stainless Steel threaded coupler (1.5" OD)
•
Power connectors (qty 3)
•
Ethernet coupler (RJ-45 jacks at each end)
Accessories are available from FLIR Systems, Inc. Contact your FLIR Dealer or integrator for up-to-
date information.
1.5.2
The installer will supply the following items, as needed (specific to the installation).
•
Water-tight enclosure for the connections
•
24 Vac or 24 Vdc power supply
•
Power cable for system power; 3-conductor, shielded, gauge determined by cable length and
supply voltage
•
Cat5e Ethernet cable for digital video and/or communications
•
Coaxial RG59U cables for analog video (up to 2, with BNC male connector at the camera end)
•
Serial cable for serial communications
•
Camera grounding strap, camera mount, miscellaneous connectors and tools
1.5.3
Connect the power, video, serial, and Ethernet connections and confirm that the video is displayed on
a monitor when the power is turned on. Confirm the camera can be controlled by moving it (pan/tilt).
Refer to
427-9030-01-12 Version 140
Camera Connection Options
Supplied Components
Required Supplies
Bench Testing
Basic Operation and Configuration, pg.
13.
March 2018
6
Advertisement
Table of Contents
