System Reset Defaults - DSC GS2060-SM Installation Manual

[991] Firmware Version
This Section will display the current firmware version of the device. Update worksheets with new version after a
flash update is completed.
[992] Ethernet IP Address
This Section will display the IP address of the Ethernet connection. This value is programmed in Section [001] or
assigned by DHCP.
[993] Ethernet Gateway Address
This Section will display the IP address of the Ethernet Gateway. This value is programmed in Section [003] or
assigned by DHCP.
[994] GPRS IP Address
This Section will display the current dynamic IP address assigned by DHCP to the GPRS connection.
NOTE: GPRS uses DHCP (Dynamic IP) only. The GPRS IP address is always provided by the GSM
network (i.e., not programmable).
[995] SIM Number
This Section will display the Subscriber Identity Module (SIM) number of the SIM card installed in the Communica-
tor. Format is: Major Industry Identifier (2 digits) Mobile Country Code (2 or 3 digits); Mobile Network Code (2 - 3
digits); Unique Number (10 - 12 digits); and Checksum (1 digit). Valid SIM numbers range is: 18 - 21 numbers. This
number is printed on SIM and the outside of the Communicator carton.
NOTE: The Checksum digit is omitted on 19 digit SIM Card numbers.
[996] GSM Telephone Number
NOTE: This Section will display the GSM telephone number of the SIM. This telephone number is
required by the Installer for DLS and remote firmware (flash) update. User can access this telephone
number by entering [*] [6] < > "GSM Phone No." to display the phone number.
[997] IMEI Number
This Section will display the unique 15 digit International Mobile Equipment Identity (IMEI) of the radio. Format is:
Reporting Body Identifier (2 digits), Allocation Number (4 digits); Final Assembly Code (2 digits); Serial Number (6
digits); and a check digit.
[998] MAC Address
This Section will display the unique12 digit, hexadecimal number assigned as the Media Access Control (MAC)
address of the device.

System Reset Defaults

[999] Software Default
Default (99);
The Software default allows the installer to refresh the unit after changes and also return the Communicator to the
default state.
00: Default Module. All programming Sections in module revert to factory settings. This will erase all existing
programming of the unit.
55: Reset. The Communicator is reset. This option is equivalent to power cycling the Communicator.
26