Safety; Symbols Used; Warnings; Notes On Ce Marking - MICRO-EPSILON capaNCDT 6500 Instruction Manual

Safety

CAUTION
NOTICE
capaNCDT 6500
1. Safety
System operation assumes knowledge of the operating instructions.
1.1

Symbols Used

The following symbols are used in these operating instructions:
Indicates a hazardous situation which, if not avoided, may result
CAUTION
in minor or moderate injuries.
Indicates a situation that may result in property damage if not
NOTICE
avoided.
Indicates a user action.
i
Indicates a tip for users.
Measure
Indicates hardware or a software button/menu.
1.2

Warnings

Disconnect the power supply before touching the sensor surface.
> Danger of injury through static discharge
The power supply and the display/output device must be connected in accordance with
the safety regulations for electrical equipment.
> Risk of injury
> Damage to or destruction of the sensor and/or controller
Avoid shocks and impacts the sensor and controller.
> Damage to or destruction of the sensor and/or controller
Protect the cable against damage.
> Failure of the measuring device
Do not plug or unplug the board (Europe size) during the operation.
> Damage to or destruction of the board in the controller
1.3

Notes on CE Marking

The following apply to the measuring system:
- EU directive 2014/30/EU
- EU directive 2014/35/EU
- EU directive 2011/65/EU, "RoHS" category 9
Products which carry the CE mark satisfy the requirements of the EU directives cited and
the European harmonized standards (EN) listed therein. The EU Declaration of Conformi-
ty is available to the responsible authorities according to EU Directive, article 10, at:
MICRO-EPSILON MESSTECHNIK
GmbH & Co. KG
Königbacher Straße 15
94496 Ortenburg / Germany
The measuring system is designed for use in industrial environments and meets the
requirements.
Page 5