Installing Siac-B Interface Connections; Figure 4-7. 93Pm Siac-B Rib Output Terminal Detail - Eaton 93PM 150 kW SIAC-B Three-Wire Installation And Operation Manual

AC Output to
UPS Rectifier

Figure 4-7. 93PM SIAC-B RIB Output Terminal Detail

4.4.2

Installing SIAC-B Interface Connections

To Install wiring:
NOTE 1
NOTE 2
NOTE 3
1. Locate the MBP interface harness removed from inside the SIAC-B in paragraph 4.4.1.
NOTE
2. Route the SIAC-B MBP auxiliary contact control interface wiring harnesses from the SIAC-B through the
bottom of the SIAC-B and UPS inter-cabinet wiring access pass-through to the UPS cabinet terminals. See
Figure 4-8 or Figure 4-9 for SIAC-B terminal locations, and Figure 4-11or Figure 4-12 for UPS terminal
locations. Refer to the applicable Eaton 93PM UPS Installation and Operation manual, listed in paragraph
1.7, for the UPS pass-through location.
Eaton 93PM Sidecar Integrated Accessory Cabinet-Bypass (150 kW and 200 kW SIAC-B) Installation and Operation Manual
Phase A (RIB-2)
Phase B (RIB-4)
Phase C (RIB-6)
The SIAC-B is attached to and directly integrated with the UPS cabinet at the factory
or after field installation on sight. This section must be used along with the
applicable Eaton 93PM UPS Installation and Operation manual, listed in paragraph
1.7, during installation.
The SIAC-B MBP auxiliary contact control interface wiring is prewired between the
attached factory installed SIAC-B and UPS. Table 4-1 and Table 4-2, and Figure 4-8
through Figure 4-13 are for reference only for the factory installed SIAC-B.
Keep interface wiring separate from power wiring.
When routing the MBP interface cable harness, ensure the green ten position
terminal header end is routed to the SIAC-B terminal block.
RIB
P-164000387—Rev 7
Installation
www.eaton.com/powerquality 4-11