Eaton 93PM 150 kW SIAC-B Three-Wire Installation And Operation Manual page 47

Do not remove or loosen the cabinet mounting or cabinet support bolts until instructed.
4. Loosen, but do not remove, the skid mounting bolts holding the pallet skids to the front and rear supports,
and to the left and right side supports (see Figure 4-1).
RISK OF INSTABILITY. Turning the jacking bolts unevenly may cause the cabinet to become
unbalanced. To prevent tipping the cabinet, raise and lower the jacking bolts evenly.
CABINET MAY TIP . Raise the SIAC-B no more than 3 mm (1/8") above the floor (just enough to
allow the removal of the pallet skids).
5. Turn each jacking bolt consecutively, two full turns, until the pallet skids clear the floor by approximately
3 mm (1/8").
6. Remove the hardware loosened in Step 4.
7 . Pull the pallet skids out from under the metal angle supports without disturbing the jacking bolts. Recycle
the pallet skids and hardware in a responsible manner.
CABINET MAY FALL. Do not loosen the hardware attaching the front supports to the cabinet base.
The cabinet must be lowered by the jacking bolts before the supports can be removed.
8. Carefully and evenly lower the cabinet by turning each jacking bolt consecutively two full turns
(maximum) until the cabinet side wheels contact the floor and the cabinet is no longer supported by the
jacking bolts.
9. After the SIAC-B is resting on the floor, remove the jacking bolts and floor protectors. Recycle them in a
responsible manner.
10. Remove the shipping brace screws securing the front left and right shipping braces to the cabinet (see
Figure 4-1). Do not reinstall screws. Recycle the screws in a responsible manner.
11. Remove the bolts securing the front left and right shipping braces to the front cabinet support
(see Figure 4-1). Remove the braces.
12. Remove the screws securing the back left and right shipping braces to the cabinet (see Figure 4-1).
Reinstall the screws (without the nylon washers) to secure the rear panel to the frame.
13. Remove the bolts securing the back left and right shipping braces to the rear cabinet support
(see Figure 4-1). Remove the braces.
14. Remove the cabinet support bolts fastening the front, rear, and side cabinet supports together and
remove the side supports (see Figure 4-1).
15. Remove the cabinet mounting bolts holding the front and rear supports to the cabinet base (see
Figure 4-1).
16. Recycle the bolts along with the shipping braces and support brackets in a responsible manner.
17 . Reinstall the SIAC-B front panel and secure with retained screw.
Eaton 93PM Sidecar Integrated Accessory Cabinet-Bypass (150 kW and 200 kW SIAC-B) Installation and Operation Manual
WARNING
WARNING
CAUTION
CAUTION
P-164000387—Rev 7
Installation
www.eaton.com/powerquality 4-3