Network > [1] Ethernet > (Choose The Bus Module Or On-Board) > [1] Module - Bosch B6512 Installation Manual

Control Panels
1
2
3
4
5
6
7
8
19
10
11
12
13
14
15
16
Personal Note
1.
2.
3.
4.
5.
6.
20.1.5 [2] Network > [1] Ethernet > (choose the bus module or on-board) > [1]
Module Parameters menu
You can use DCHP/AutoIP or UPnP for Ethernet communication with the on-board Ethernet or
a B426. In this menu, you can enable and disable these protocols.
DHCP/AutoIP Enable
UPnP Enable
IPv4 Address
IPv4 Subnet Mask
Default Gateway
HTTP Port Number
IPv4 Server Address
Bosch Security Systems, Inc.
______________________________________________________________________
______________________________________________________________________
______________________________________________________________________
______________________________________________________________________
______________________________________________________________________
______________________________________________________________________
______________________________________________________________________
______________________________________________________________________
______________________________________________________________________
______________________________________________________________________
______________________________________________________________________
______________________________________________________________________
______________________________________________________________________
______________________________________________________________________
______________________________________________________________________
______________________________________________________________________
Enter the installer passcode, and then open the [1] Installer Menu.
Go to [1] Programming Menu > [1] Reporting > [4] Personal Note. The keypad shows
the phone number or email address of the selected personal notification destination.
Use /Previous or /Next to scroll through the list of destinations and go to the
destination you want to program.
Press Edit or Enter to edit the phone number or email address.
Delete existing characters, if necessary, and then enter the new characters.
Press Save or Enter. The keypad shows Parameter saved.
Default Module settings
Yes Yes/No
Yes Yes/No
0.0.0.0 _______________________________
255.255.255.255 _______________________________
0.0.0.0 _______________________________
80 _______________________________
0.0.0.0 _______________________________
Installation Manual
Keypad Installer menu | en 105
2018.07 | 16 | F.01U.287.180