Network > [1] Ethernet > (Choose The Bus Module Or On-Board) > [2] Address - Bosch B6512 Installation Manual

106 en | Keypad Installer menu
IPv6 Server Address
Module Hostname
DHCP/AutoIP Enable
1.
2.
3.
4.
5.
UPnP Enable
1.
2.
3.
4.
5.
20.1.6 [2] Network > [1] Ethernet > (choose the bus module or on-board) > [2]
Address Parameters menu
IPv4 Address
1.
2.
3.
4.
5.
6.
IPv4 Subnet Mask
1.
2.
3.
2018.07 | 16 | F.01U.287.180
Enter the installer passcode, and then open the [1] Installer Menu.
Go to [1] Programming Menu > [2] Network > [1] Ethernet > (choose the bus module or
on-board) > [1] Module Parameters > [1] DHCP Enable. The keypad shows the DHCP/
AutoIP current configuration.
Depending on the keypad model:
Press Yes or No.
-or-
Press Enter to edit the DHCP/AutoIP Enable configuration for the module. Use Previous
or Next to toggle between Yes and No..
Press Save or Enter. The keypad shows Parameter saved.
Escape from the menu.
Enter the installer passcode, and then open the [1] Installer Menu.
Go to [1] Programming Menu > [2] Network > [1] Ethernet > (choose the bus module or
on-board) > [1] Module Parameters > [2] UPnP Enable. The keypad shows the UPnP
current configuration.
Depending on the keypad model:
Press Yes or No.
-or-
Press Enter to edit the UPnP Enable configuration for the module. Use Previous or Next
to toggle between Yes and No..
Press Save or Enter. The keypad shows Parameter saved.
Escape from the menu.
Enter the installer passcode, and then open the [1] Installer Menu.
Go to [1] Programming Menu > [2] Network > [1] Ethernet > (choose the bus module or
on-board) > [1] Module Parameters > [2] Address Parameters > [1] IP Address.
Press Edit or Enter to edit the IP address.
Delete the existing number, if necessary, and then enter the new number. Use
Previous or /Next to move through the different bytes.
Press Save or Enter. The keypad shows Parameter saved.
Escape from the menu.
Enter the installer passcode, and then open the [1] Installer Menu.
Go to [1] Programming Menu > [2] Network > [1] Ethernet > (choose the bus module or
on-board) > [1] Module Parameters > [2] Subnet Mask.
Press Edit or Enter to edit the subnet mask address.
0.0.0.0 _______________________________
Blank _______________________________
Installation Manual
Control Panels
/
Bosch Security Systems, Inc.