SMART Board 6065 HD Installation And Maintenance Manual page 4

IMPORTANT INFORMATION
Disconnect all of the display's power cables from the wall outlet and seek assistance from
l
qualified service personnel if any of the following occur:
The power cable or plug is damaged
o
Liquid is spilled into the display
o
Objects fall into the display
o
The display is dropped
o
Structural damage, such as cracking, occurs
o
The display behaves unexpectedly when you follow operating instructions
o
CAUTION
Before you clean the display's screen, shut down or disconnect the computer. Otherwise,
l
you may scramble the desktop icons or inadvertently activate applications when you wipe
the screen.
Avoid setting up and using the display in an area with excessive levels of dust, humidity and
l
smoke.
Dust buildup on the camera windows and reflective tape will degrade touch performance.
l
SMART recommends that you inspect the camera windows and reflective tape for buildup
and clean weekly.
Make sure an electrical socket is near the display and remains easily accessible during use.
l
The display should be used only with European TN and TT power distribution systems.
l
It is not suitable for older, IT-type power distribution systems found in some European
countries. "This system (IT-type) is widely used isolated from earth, in some installations in
France, with impedance to earth, at 230/400V, and in Norway, with voltage limiter, neutral
not distributed, at 230V line-to-line." (IEC 60950:1999)
Contact qualified personnel if you're uncertain of the type of power system available where
you're installing the display.
The accessory slot's maximum available power is 60 W. The slot is not a limited power
l
source. To reduce the risk of fire, make sure that accessories connecting to the slot satisfy
the fire enclosure requirements of IEC 60950-1.
You must connect the USB cable that came with the display to a computer that has a USB
l
compliant interface and that bears the USB logo. In addition, the USB source computer must
be compliant with CSA/UL/EN 60950 and bear the CE mark and CSA and/or UL Mark(s) for
CSA/UL 60950. This is for operating safety and to avoid damage to the display.
ii smarttech.com/kb/171204