Chapter 3: Connecting Power And Devices; Connecting Power - SMART Board 6065 HD Installation And Maintenance Manual

Chapter 3
Connecting power and devices
Connecting power
Connecting cables for room computers, guest laptops and other input sources
Using recommend cables
Connecting to the display
Viewing a connected computer or other device's input
Connecting external speakers
Connecting room control systems
Connector reference
Connect the display to power after you install it but before you turn it on for the first time. You can
also connect cables for room computers, guest laptops or other input sources as well as for
speakers and room control systems.
By installing cables in advance, you make use of connectors that might not be accessible after the
display is wall-mounted. You can then run the cables across floors or behind walls as needed.
WARNING
Ensure that any cables that cross the floor to the display are properly bundled and marked to
avoid a trip hazard.

Connecting power

Connect the supplied power cable from the AC power
inlet on the bottom of the display to a power outlet.
21 smarttech.com/kb/171204
21
22
22
23
23
23
24
25