Using The Battery Case - Sony CCD-TRV19 Operation Manual (primary manual) Operation Manual

Using alternative power sources
Notes on the POWER lamp
• The POWER lamp will remain lit for a while even if the unit is unplugged after use.
This is normal.
• If the POWER lamp does not light, set the selector to VTR (DC OUT) and disconnect
the power cord. After about one minute, reconnect the power cord.
To remove the adaptor
The adaptor is removed in the same way as the battery pack.

Using the Battery Case

– CCD-TRV11/TRV19/TRV21/TRV29 only
Use the battery case (supplied) and six size AA (LR6) alkaline batteries (not supplied).
(1) Remove the battery holder from the battery case.
(2) Insert six new alkaline batteries into the battery holder, following the marking
on the holder to be sure the batteries are installed in the correct direction.
(3) Insert the battery holder with the alkaline batteries.
(4) Insert the battery case with the alkaline batteries to the battery mounting
surface of the camcorder in the same way as the battery pack (p. 7).
1
Battery Life
Using alkaline batteries at 77°F (25°C)
Model
LCD open
While
1)
recording
LCD close
While playing back on
LCD 3)
1) Approximate continuous recording time indoors is indicated outside of parentheses.
Approximate minutes when recording while you repeat recording start/stop,
zooming and turning the power on/off are indicated in parentheses. The actual
battery life may be shorter.
2)
Approximate minutes when using the LCD screen. When using both the viewfinder
and LCD screen, the battery life is shorter.
3)
Approximate continuous playback time indoors.
If the LCD BACK LIGHT switch is set to BRIGHT while the LCD screen is open, the
battery life is approximately 10% shorter.
20
2
CCD-TRV11/TRV19
2)
125 (70)
170 (95)
120
CCD-TRV11/TRV19/TRV21/TRV29/TRV119/TRV211 3-810-780-23.E
3
CCD-TRV21/TRV29
110 (60)
150 (85)
115