Hardware Installation - ICP DAS USA PCI-1002L User Manual

PCI-1002 Series Card
12-bit, 110 kS/s or 44 kS/s Multi-function Board
3.

Hardware Installation

Note:
It is recommended that the driver is installed before installing the hardware as the computer may need to be
restarted once the driver is installed in certain operating systems, such as Windows 2000 or Windows XP, etc.
Installing the driver first helps reduce the time required for installation and restarting the computer.
To install the PCI-1002 series card, follow the procedure described below:
Step 1: Install the driver for your board on Host computer.
Step 2: Configure the Card ID using the DIP Switch (SW1).
For detailed information about the card ID (SW1), please refer to
Section 2.4 "Card ID Switch"
Note
The Card ID function is only supported by the PEX-1002L/H.
User Manual, Ver. 3.0, Jun. 2018, PMH-015-30, Page: 23
For detailed information about
the driver installation, please
refer to Chapter 4 "Software
Installation".
.