Cable Housing Installation - Argon 18 E-117 TRI 285A Assembly Manual

E-117 TRI 285A / 285B: 9. Cable Housing Installation
D
C
A
Suggested lengths of the cable housing inside the frame*
(the medium frame is used as a reference)
Cable housing/length
A FRONT brakes
(KEB 5mm)
B1 REAR brakes
(KEB 5mm)
B2
REAR brakes rear section
C
FRONT derailleur
(LEX 4mm)
D
REAR derailleur
(LEX 4mm)
* Does not include handlebar section, as too many variations can occur.
B1
NA
66cm
(KEB 5mm) 13cm
66cm
66cm
IMPORTANT: Install cable housing
before installing the bottom
bracket, crank, and fork.
Handlebar Section
Standard housing and metal cap
according to lever manufacturer's
recommandations. For brakes
and gears, housing lengths may
vary depending on needs but
ideally they should all connect
without the barrels entering the
frame (triangular holes).
Front
derailleur
1.5
Rear brake
Note: For maximum braking
B2
performance it is strongly
recommended to use the non-
compressible jagwire KEB housing
(Jagwire 5mmKEB-SL).
Rear
derailleur Di2 cable
1.6
Rear brake
14