Cable Housing Installation - Argon 18 nitrogen Assembly Manual

NITROGEN : 3. Cable housing installation
B
A
A
: 5mm barrel adj.
B
: 4mm barrel adj.
C
: metal cap "pop"
D
: metal cap for rear derailleur
brake adjustment :
speed adjustment :
Suggested lengths of the cable housing
XS
housing/size
Front brake 40cm
Rear brake front section 30cm
Rear brake rear section 20cm
Front derailleur 110cm
Rear derailleur 185cm
A
3
A+C
B
S
M L
45cm 50cm 55cm
35cm
40cm 45cm
20cm
20cm 25cm
110cm
120cm 125cm
190cm 195cm 200cm
brake and speed adjustment
2
It's better to install cables housing before
installing the bottom bracket, crank and fork.
1. Install the rear derailleur cable
housing starting at the drive side's
drop-out until it comes out in the top
tube.
2. Install the front derailleur cable
housing starting under the bottom
bracket shell.
3. Install the rear brake cable housing
(see page 8 for details). Use supplied
Jagwire housing (KEB).
Note: For maximum braking performance
it is strongly recommended to use the
non-compressible jagwire KEB housing
(Jagwire 5mmKEB-SL / RCK###).
See the table below for the cable housing
length suggested.
1
D
6