IBM 3180 1 User Manual page 30

4.8
Setup is complete on this display station.
j
n "N
22
If the conditions in step 4.7 do not occur, do the
following:
1. Ask the system operator if the system or control unit
to which your display station is connected is operating
and able to recognise your display station.
2. Make sure the cable attachment module is connected correctly.
3. Set the Power switch to Off and check the cable connections
at both ends to make sure they are properly positioned and
tightened.
4. Set the Power switch to On.
Do the conditions in step 4.7 occur now?
Yes No
Setup is complete. Chapter 4, Fixing
Display Station
Problems
C9468024