r \
5. The following display will appear with two horizontal bars
blinking alternately in the lower left quadrant.
IEEEEEEEEEEEEEEEEEEEEF.EEEEEEEEEEEEEEEEEJEEEEEEEEEEEEEEEEEEEEEEEEEEEEEEEEF.EEEF.EEJ
aaaa*aaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaa«
H
"
H HHHKIIHHHKHHHHHHHHKKHHHHHHHHHHHimHHKHH H
H mmmiiBi
eS E E
£ i
«EEEEEEEEEEEEEEEEEEEEEEEEEEEEEEEEEEEEEE«EEEEEEEEEEEEEEEEEEEEEEEEEEEEEEEEEEEEEEE«
Does the display appear with the two horizontal bars blinking
in the lower left quadrant?
Yes
No
Replace the logic element.
(Go to Chapter 5.)
If the problem still exists,
replace the cable attachment
module.
1. Set the Power switch to Off.
2. Reconnect the cable to the cable attachment module.
3. Set the Power switch to On.
Your display station should be operational. If it is not, begin
the CPAR again. If you still cannot locate the procedure to
correct your problem, contact your IBM sales representative.
C946S058
Chapter 4. Fixing Display Station Problems 95