Load Optimized Defaults; Set Supervisor/User Password - AXIOMTEK AX12270 User Manual

AX12270 PC/104 Module Series User's Manual
4.13

Load Optimized Defaults

This option allows you to load the default values to your system
configuration. These default settings are optimal and enable all high
performance features. To load BIOS defaults value to CMOS SRAM,
enter "Y". If not, enter "N".
4.14

Set Supervisor/User Password

You can set either supervisor or user password, or both of then. The
differences between are:
1.
Supervisor password: can enter and change the options of the
setup menus.
2.
User password: just can enter but do not have the right to change
the options of the setup menus.
When you select this function, the following message will appear at the
center of the screen to assist you in creating a password.
Type the password with eight characters at most, and press <Enter>.
The password typed will now clear any previously entered password
from CMOS memory. You will be asked to confirm the password. Type
the password again and press <Enter>. You may also press <Esc> to
abort the selection and not enter a password.
To disable password, just press <Enter> when you are prompted to
enter password. A message will confirm the password being disabled.
Once the password is disabled, the system will boot and you can enter
Setup freely.
When a password is enabled, you have to type it every time you enter
Setup. This prevents any unauthorized person from changing your
system configuration.
Additionally when a password is enabled, you can also require the
BIOS to request a password every time the system reboots. This would
prevent unauthorized use of your computer.
54
ENTER PASSWORD:
PASSWORD DISABLED.
Award BIOS Utility