8.5
Rear Panel Detail
The rear control panel contains the following functions (BCD-09809).
8.5.1
Power Cord
The power cord is 8-foot (2m) in length, type "SVT" molded plug, allowing for long life and easy
cleanability.
8.5.2
Circuit Breaker
All control electronics are protected with a circuit breaker that may trip at 110% of load rating, but
will trip at 145% of load rating in less than 2 seconds. Should the circuit breaker open (pop-out
button will appear), merely depress to reset.
8.5.3
CO
Inlet
2
The CO
2
pressure to insure proper flow rates and consistent CO
8.5.4
Air Inlet
The Incubator is provided with clear vinyl tubing and a 0.3-micron HEPA filter. This is a free air
supply. DO NOT CONNECT TO A PRESSURIZED SOURCE.
8.5.5
Power Switch
The power switch, located at the top of the rear panel, controls all power to the Incubator.
8.5.6
Internal Tank Switch (Option)
The internal tank switch is an option, which is customer installed in the field, or at the time of
manufacture. The tank switch performs the critical back-up function of switching tank 1 and tank
2 and back again when each depleted tank is replaced.
8.5.7
Communication Interface/Alarm
Three receptacle connectors are provided for direct field connection of a computer/printer, remote
alarm indicator and chart recorder.
OM0135
inlet provides a fitting for vinyl tubing. Be sure to follow the recommended inlet
percentage readings.
2
23