Option Configuration Parameters; To Exit The Function Parameters - NuAire NU-5510 Operation And Maintenance Manual

8.8.1.2 Option Configuration Parameters (Evaluation Unit 6-03)
1) - CO
2) - CO
3) - CO
4) - Closed Door CO
5) -Alarm Audible Enable (on/off)
6) - Decon. Cycle (95/145) (Selects Decon Cycle)
7) - Password Protection (on/off)
8) - Auto Zero (on/off)
9)
10)
11)
12)
13)
14)
15)
16)
17)
18)
19)
(Note: Default values are in bold)
Once you have made your menu selection, you will remain within that menu selection until you exit the diagnostic
mode. If another menu selection is desired, you must re-enter the diagnostic mode via the hidden key.
To exit the function parameters, press the hidden key (flag on NuAire logo).
1 - CO System Enable
2
This function will enable or disable the CO
The value display will show "on" or "off" corresponding to
the current condition. In run mode, the CO
will indicate either the CO
or nothing when the system is off.
OM0135
System Enable (on/off)
2
Tank 2 Enable (on/off)
2
Auto Switch Back (on/off)
2
Zero/Span Calibration (on/off)
2
- CO Inject Delay Time (seconds/60)
2
- Door Delay Time (seconds/40)
- Air Inject Time (seconds/35)
- Air Inject Cycle (minutes/10)
- Print Frequency Time (minutes/0)
- Temperature Time Out (minutes/240)
- CO Time Out (minutes/30)
2
- Temperature Recovery Delay Time (seconds/30)
- Temp. Sensor Differential (C/4.0)
- Temp. Max. Above Set point (C/1.0)
- CO Max. Above Set point (%/1.0)
2
system.
2
percent display
2
percent when the system is on,
2
29