Front Component Panel - NuAire 12 Series Operation And Maintenance Manual

8.6 Front Component Panel

The front component panel contains the following functions. See 18316
8.6.1 CO2 Supply Filter
The CO2 supply filter is installed at the factory and should be changed following the instructions found in
Maintenance Section 10.
8.6.2 Air Inlet Filter - All models
The Air Inlet Filter is installed at the factory and should be changed following the instructions found in Maintenance
section 10. This is a free air supply.
8.6.3 Chamber sample port
The Sample port is provided for checking the CO
determine if it needs adjustment.
8.6.4 Sensor bay access panel
Provides access to the CO2 sensor, Capsule Filter and the Hydrophobic filter for maintenance.
OM0245
Rev 6 March/2022
Note: DO NOT CONNECT TO A PRESSURIZED SOURCE.
2
Page 25 of 53
level in the chamber to monitor the calibration the Sensor and