Preset Menu - High End Systems SolaFrame 3000 User Manual

Preset Menu

Set the Playback Settings
Navigate: Main Menu → Preset → PlayBack
Playback settings allow you to run an Auto Program as a Master fixture or in stand-alone mode,
or to receive playback information from a different Master fixture.
Preset programming requires one fixture to act as the Master. All other SolaFrame 3000 fixtures
that are connected to the designated Master fixture can then receive Auto Programs from the
Master fixture.
Example: You edit groups of scenes into Programs 1–10 on the Master fixture.
- Program 2 is assigned to Part 1
- Program 4 is assigned to Part 2
- Program 6 is assigned to Part 3
* Fixtures assigned as Slave 1 will play back Part 1
* Fixtures assigned as Slave 2 will play back Part 2
* Fixtures assigned as Slave 3 will play back Part 3
Select the appropriate playback setting:
DMX Control: Return the fixture to DMX control from another playback mode.
•
Set To Slave: Fixture will play back the Auto Program that is defined on the Master fixture.
•
Auto Program: Fixture runs an Auto Program either in stand-alone mode or as a Master
•
fixture. Use the Select Prog parameter to select the program (see
Program
Select an Auto Program
Navigate: Main Menu → Preset → Select Prog.
Select the Auto Program that the fixture will run either in stand-alone mode or as a Master
fixture.
Program
Prog. Part 1
Prog. Part 2
Prog. Part 3
Edit an Auto Program
Navigate: Main Menu → Preset → Edit Program
Create the Auto Program that the fixture will run either in stand-alone mode or as a Master
fixture (see Select an Auto Program
Navigate to the Auto Program that you want to edit (Program 1, Program 2, etc.), and then set
the Scene (SC001, SC002, etc.) for each step (Step 01, Step 02, etc.) in the Auto Program. You
can set a maximum of 64 steps. The SolaFrame 3000 fixture provides 250 pre-programmed
Scenes, or you can customize scenes using the Edit Scenes parameter (see
Capture (Record) a Scene on the next
Configure the Fixture
below).
Program 1–Program 10
Program 1–Program 10
Program 1–Program 10
Range
above).
page).
Select an Auto
Default Value
Program 1
Program 2
Program 3
Edit a Scene or
21