Tilt movement
This message displays after the reset of the fixture if any of the following conditions exist:
if the fixture head magnetic-indexing circuit malfunctions (optical or magnetic sensor
•
failure)
if the stepper motor is defective or the related IC driver on the main PCB has failed
•
if the Tilt movement is not located in the default position after the reset
•
Zoom Wheel
This message displays after the reset of the fixture if any of the following conditions exist:
if the magnetic-indexing circuit malfunctions (optical or magnetic sensor failure)
•
if the stepper motor is defective or the related IC driver on the main PCB has failed
•
if the Zoom movement is not located in the default position after the reset
•
Error Codes
25