High End Systems SolaFrame 3000 User Manual page 23

Set Display Settings
Navigate: Main Menu → Set → Disp. Setting
Parameter
Shutoff Time
Flip Display
Key Lock
Set the Temperature Scale
Navigate: Main Menu → Set → Temp. C/F
Select the temperature scale for the fixture:
Celsius (default value)
•
Fahrenheit
•
Update Fixture Firmware Using the USB Port
Navigate: Main Menu → Set → USB Update
Fixture firmware updates are available on the High End Systems, Inc. website at highend.com.
1. Save the firmware update file to a USB stick.
2. Insert the stick in the fixture base (see
location).
On the Main Menu, select Set → USB Update. The fixture reads the USB stick and
3.
displays a list of any firmware update files on the USB stick.
4. Select the appropriate file and then press the Enter button.
5. The software prompts you to confirm the update with the message "Update fixture?" Use
the navigation buttons to select "Yes," and then press the Enter button.
The firmware update begins. A progress monitor shows you the progress of the
•
update.
The fixture restarts when the update is complete, and the fixture performs a data
•
check to verify the update.
The firmware update is complete when the display returns to its default state.
•
6. Remove the USB stick from the fixture.
Reset Fixture to Factory Default Settings
Navigate: Main Menu → Set → Reset Default
Select ON to reset the fixture to the factory default settings.
Configure the Fixture
Value
Enter the amount of time the fixture waits after the
02–60 minutes last user interface button press until the display goes
to sleep. The default value is 5 minutes.
ON
Flip the display 180° when the fixture is mounted ver-
•
tically. The default value is Off.
OFF
•
Lock the user interface. The default value is Off.
ON
To unlock the user interface buttons when locked,
•
press and hold the [MODE/ESC] button for three
OFF
•
seconds.
Description
Fixture Overview on page 4 for the USB port
19