Panasonic KX-TD500 Installation Manual page 227

4.5.10 Voice Mail Integration
Value Range
Parameter
(default)
Voice Mail Commands
The following parameters (up to 16 digits for each) can be programmed using " 0 through 9," ". ," "#" and "H."
Leave Message
Get Message
AA Service
VM Service
4-88 System Programming
(H) Specifies the Leave Message command.
This command is transmitted to a VM port if a call is
forwarded or intercepted and rerouted to the VM port.
( H) Specifies Get Message command.
This command is transmitted to a VM port when the
message receiver presses the MESSAGE button to
retrieve voice message.
(#8) Specifies AA (Automated Attendant) Service command.
If AA Service is set to "Start" by system programming,
this command is sent to a VM port if an incoming CO
call is answered by the VM port.
(#6) Specifies VM (Voice Mail) Service command.
This command is transmitted preceding the "Get
Message" command above. This is effective to switch
to a VM port when an AA port lights the MESSAGE
indicator.
This command is also transmitted preceding the "Leave
Message" command if Operator transfers a call to an
extension and then it is forwarded to an AA port so that
the AA port can be switched to VM port temporarily.
Description/Function Reference