Degassing The Water; Setting Up The Reservoirs - Thermo Scientific Dionex ICS-5000+ Installation Instructions Manual

+
Dionex ICS-5000 Installation Instructions
Removing a Tube from a Fitting
After a tube has been pushed fully into a fitting, it is locked in place. To
remove the tube, use the fingers of one hand to press the rubber ring on the
fitting and simultaneously pull out the tubing with the other hand.
3.11

Degassing the Water

Degas the deionized water that will be used to fill the eluent reservoir. For
deionized water specifications for ion chromatography, see
3.12

Setting Up the Reservoirs

The following reservoirs are available for use with the DP/SP:
•
1-liter plastic reservoir (P/N 063291)
•
2-liter plastic reservoir (P/N 062510)
•
4-liter plastic reservoir (P/N 063292)
Do not use the plastic reservoirs for offline vacuum degassing of
eluents. The reservoirs were not designed for this purpose.
N'utilisez pas le réservoir en plastique pour le dégazage à vide hors
ligne d'éluants. Le réservoir n'a pas été conçu à cette fin.
64
Figure 3-33. Removal of a Drain Tube from a Fitting
Press the
rubber ring
Pull out
the tubing
Table 1-1.
Doc. 065447-02 12/14