Adjusting The Thread Trimmer Air Cylinder; Air Cylinder Stroke; Air Cylinder Return Spring; Solenoid - KANSAI SPECIAL WX8803/UTC Instruction Manual

【3】ADJUSTING THE THREAD TRIMMER AIR CYLINDER

3 3 3 3 - - - - 1 Air cylinder stroke

1 Air cylinder stroke
1 Air cylinder stroke 1 Air cylinder stroke
The stroke of the air cylinder should be
approximately 15mm.
by loosening collar B and screw A.
should be a clearance of 15mm between rubber
cushion F and the rear end of the cylinder.
Position joint shaft E so that the distance from
left end of the cylinder mounting bracket D to
the center of joint shaft E is approximately
55.3mm when the cylinder retracts.
Adjustment is made by loosening nut C. In these conditions, there should be a clearance
of approximately 19mm between thread releaser block H and cylinder mounting bracket
D.

3 3 3 3 - - - - 2 Air cylinder return spring

2 Air cylinder return spring 2 Air cylinder return spring 2 Air cylinder return spring
There should be a clearance of approximately 28mm
between ring G and air cylinder mounting bracket D
when the plunger of the air cylinder protrudes.
【4】ADJUSTING THE THREAD TRIMMER SOLENOID

4 4 4 4 - - - - 1 Solenoid stroke

1 Solenoid stroke 1 Solenoid stroke 1 Solenoid stroke
The stroke
approximately 15mm.
by removing rubber cover F and loosening
screw A.
There should be a clearance of 15mm between
rubber cushion B and the rear end of the

solenoid.

Position joint shaft E so that the
distance from
mounting bracket D to the center of joint shaft
E is approximately 55.3mm when the solenoid
has retracts. Adjustment is made by loosening nut C. In these conditions, there should
be a clearance of approximately 19mm between thread releaser block J and solenoid
mounting bracket D.

4 4 4 4 - - - - 2 Adjusting the solenoid return spring

2 Adjusting the solenoid return spring
2 Adjusting the solenoid return spring 2 Adjusting the solenoid return spring
There should be a clearance of 42mm between solenoid
return spring collar H and solenoid mounting bracket
D when the plunger of the solenoid protrudes.
Adjustment is made by loosening screw G on solenoid
return spring collar H.
Adjustment is made
of the solenoid
Adjustment is made
the left end of
There
should be
solenoid
2