Protection From Electric Shock; Protection From Burns And Fire; Protection From Injury - Chroma Studio Force II 12 User Manual

PROTECTION FROM ELECTRIC SHOCK

•
Use only the cables specified in this manual and on the Chroma-Q website at
www.chroma-q.com
not long enough for an intended cable run, consult Chroma-Q for assistance in finding or
creating a safe alternative solution.
•
Provide a means of locking out AC mains power that allows power to the installation to
be shut down and made impossible to reapply, even accidentally, during work on the
installation.
•
Shut down power to the installation during service and when it is not in use.
•
Before applying power to the installation, check that all power distribution equipment and
cables are in perfect condition and rated for the current requirements of all connected
devices.
•
Isolate the installation from power immediately if any product, power cable or power plug
is in any way damaged, defective or wet, or if it shows signs of overheating.
•
Do not immerse a Chroma-Q Studio Force II
pressure water jets.

PROTECTION FROM BURNS AND FIRE

•
The Studio Force II
airflow around the fixture and a minimum clearance of 10 mm (0.4 in.) in all directions.
•
Do not operate the Studio Force II
C (104°F).
•
Do not modify the Studio Force II
other than genuine Chroma-Q parts. Use only accessories approved by Chroma-Q.

PROTECTION FROM INJURY

•
Ensure that the installation hardware and supporting surface or structure can hold at least
10 times the weight of all the devices they support.
•
Block access below the work area and work from a stable platform whenever installing,
servicing or moving the Studio Force II
•
As soon as work is completed, check that all hardware and components are securely
fastened to supporting structures.
•
Make sure there are no flammable materials close to the product during operation.
•
Make sure the power cord is not crimped or damaged.
•
Avoid direct eye exposure to the light source while the product is on.
•
Never try to repair the product. Repairs carried out by unskilled people can lead to
damage or malfunction and/or invalidate your warranty. Please contact the nearest
authorized dealer or contact support@chroma-q.com.
to interconnect devices in the installation. If the specified cables are
TM
is designed to be cooled by forced air convection. Provide free
TM
TM
Keep this User Manual for future consultation. If this product is used by another
user, be sure that they also receive this document.
www.chroma-q.com
TM
fixture in water or expose it to high-
if the ambient operating temperature exceeds 40°
in any way not described in this manual or install
TM
.
iv