Chroma Studio Force II 12 User Manual page 24

Upload Engine
RECOMMENDED ONLY FOR FACTORY TRAINED PERSONNEL.
LED Engine software can be uploaded to the fixture from the Chroma-Q Uploader II by accessing this menu.
Refer to the Quick Start Guide of the Chroma-Q Uploader II.
Link: http://www.chroma-q.com/support/quick-start/CHUSBLOADERII_Uploader-quickstartguide.pdf
Software for the LED engines must be uploaded to the Studio Force II
In "Setup", select "Upload Engines" then press Enter, and the display shows "Ready"
Connect an XLR 5-pin cable from the Uploader to the individual Studio force II unit
Power-up the Uploader - display shows the file name, and "Ready"
Press the "ERASE TARGET" button once to clear the target firmware
Press the "Start Uploading" button once to execute the uploading
An animated progress is displayed on the Uploader and CF unit indicating the upload
process
"UPLOADING DONE" appears on the Uploader upon completion of a successful
upload and the target device resets to the Main Menu
Power-cycle the unit
Note: The Chroma-Q Uploader II must be purchased separately.
FW Version
This screen displays current software version of fixture at the address header. For added versatility,
Individual firmware versions of all the engines are also displayed.
DMX Source
This enables the input connection.
Figure 19 (DMX Source Select Screen)
Select the DMX source and press Apply.
Engine Temp
Tap on this to see individual temperature in ºCelsius of each engine in the fixture. Each LED engine drives
two cells on the Studio Force II
Figure 20 (Light Engine Temp Screen)
INPUT
CABLE
WIRELESS Lumen Radio input
TM
.
www.chroma-q.com
19
TM
using the Chroma-Q Uploader II:
DMX from console via cable