Chroma Studio Force II 12 User Manual page 16

Mode Options
Cine-Q 16b The crossfade parameter can be set to 16-bit for a more accurate crossfade and better
granularity, when using very long transition. When set at this mode, one extra channel (#9) is assigned for
very small step increase/decrease in the intensity (0.0% to 1.0%) with change in the DMX fader value form
0-255. See Table 21 (DMX Map-CINE-Q-iKHRGBW-16bit) for the DMX Map.
Mode i
Cine-Q 8b 1
Cine-Q 16b 1
**Extended This setting assigns one extra channel in the end, which allows remote override of certain
settings such as engine frequency, fan speed, Dimmer curve and DMX Lost state. This option allows users
to temporarily override touch screen menu entered settings, using one extra channel on a DMX console.
To override a current setting in the fixture,
1. Set the value of this channel to the desired setting (DMX Value) listed in the Table 23 (DMX Map-
Extended Control Channel).
2. Wait for 5 sec.
3. The fixture will retain that setting, until it is changed again or the fixture is power cycled.
4. To avoid any unintentional settings override, set the extended channel back to DMX value 0.
After the power cycle, the extended control setting will be reset and the fixture will default back to the last
settings set by the touch screen display menu or the RDM.
HSi Legacy The option allows the new Studio force fixtures match the HSi pattern, with old Chroma-Q HSi
mode enabled fixtures. With Legacy hue mode enabled, the Hue channel is from Blue to Blue (B→G→R→B).
K H R
2 3 4
2 3 4
www.chroma-q.com
G B W
5 6 7
5 6 7
11
X x
8 --
8 9