Chroma Studio Force II 12 User Manual page 21

PWM Frequency
The Studio Force II has following frequency settings available: 750 Hz, 1500 Hz, 3000Hz, 6000 Hz,
12000Hz, 24000Hz. This allows for the LED scan rate to be synchronized with the video camera and avoid
a flickering effect.
Trade-off: Better dimming is achieved at lower frequencies; flickering effect is minimized at higher PWM
frequencies.
Figure 14 (PWM Select Screen)
To set the Frequency,
DMX Lost
If DMX is not detected various output options can be selected in this mode:
Figure 15 (DMX Lost Mode Select Screen)
To set DMX Lost action;
Note: If a Look is selected for playback when DMX is lost, the unit will playback the selected look on power
up, as long as DMX is not present.
On the Main Menu, tap Setup Menu
On the Setup screen, tap Frequency
On the Frequency screen, select and tap a Frequency option, then tap Apply to save
On the Main Menu, tap Setup Menu
On the Setup screen, tap DMX Lost
On the When DMX Lost screen, select and tap an output option, then tap
Apply to save
www.chroma-q.com
OFF will snap to off after 5 seconds
Hold will hold the last valid DMX state
Look 1-31 will snap to the user saved look
16