Hot Plugging; Hot Plugging Stations; Hot Plugging Kvm Ports; Hot Plugging Console Ports - ATEN CS1708i User Manual

CS1708i / CS1716i User Manual

Hot Plugging

The CS1708i / CS1716i supports hot plugging – components can be removed
and added back into the installation by unplugging and replugging their cables
from the switch's ports without the need to shut the unit down. In order for hot
plugging to work properly, however, the procedures described below must be
followed:

Hot Plugging Stations

You can change a station's position by simply disconnecting it from its master
and reconnecting it to another switch in the chain. In order for the OSD menus
to correspond to the change, the station IDs must be reset in the OSD.
See RESET STATION IDS, page 35 for details.

Hot Plugging KVM Ports

After switching KVM ports, in order for the OSD menus to correspond to the
change, you must manually reconfigure the OSD information for the new Port
information. See F3: SET, page 32, and the Port Setting selections under the
F4 ADM function, page 34, for details.
Note: If the computer's Operating System doesn't support hot plugging, this
function may not work properly.

Hot Plugging Console Ports

The keyboard, monitor, and mouse can all be hot plugged. When hot plugging
the mouse:
 You may unplug and replug the mouse (to reset the mouse)
Note: If, after hot plugging there is no response to keyboard and/or mouse
input, perform a Keyboard and Mouse Reset by simultaneously
pressing the 1 and 2 front panel port LEDs.
24