Stacking And Rack Mounting; Stacking - ATEN CS1708i User Manual

CS1708i / CS1716i User Manual

Stacking and Rack Mounting

The CS1708i / CS1716i can be stacked on the desktop or rack mounted at the
front or rear of the rack. The following sections take you through the
procedures for each method.
Note: 1. Allow at least 5.1 cm on each side for adequate ventilation and
12.7 cm at the rear for power cord and cable clearance.
2. The standard rack mounting kit does not include screws or cage nuts.
If you need additional screws or cage nuts, contact your rack dealer.

Stacking

The CS1708i / CS1716i can be placed on any level surface that can safely
support its weight and the weight of the attached cables. Make sure that the
surface is clean and free of any materials that can block the exhaust vents or
otherwise interfere with normal operation of the switch.
To place the CS1708i / CS1716i, or to stack units if you are daisy chaining
them, remove the backing material from the bottom of the rubber feet that came
with this package, and stick them onto the bottom panel at the corners, as
shown in the diagram, below:
14