Restoring Factory Default Settings - ATEN CS1708i User Manual

Restoring Factory Default Settings

You can restore the factory default settings (listed on the next page) for the
CS1708i / CS1716i. With this procedure, the administrator and all user
accounts are removed from the system. All port names and setting are also
removed.
Note: 1. A jumper cap is required when performing this procedure.
2. If your Administrator login information has become corrupted, or you
have forgotten it), this procedure to reset the original defaults (see
page 27).
1. Unplug the CS1708i / CS1716i's power adapter.
2. Place a jumper cap over pins 1-2 of the mainboard jumper labeled J17.
3. Plug in the power adapter. The following directions appear on the KVM
console screen:
USERNAME AND PASSWORD INFORMATION AND PORT/USER
INFORMATION HAS BEEN CLEARED. PLEASE POWER OFF THE
SWITCH, REMOVE THE JUMPER, CLOSE THE CASE, THEN
RESTART.
4. Unplug the power adapter again.
5. Remove the jumper cap from the jumper.
6. Close the housing and plug the power adapter in again.
After powering on the unit, you can use the default username and
password to log in.
Appendix
193