Turning The Pump On And Off; Entering Settings; Purging The Pump - Agilent Technologies G1323B User Manual

1200 series handheld control module

Table of Contents

Using the Pump

Turning the Pump On and Off

To turn the pump on or off you can use the On/Off button [F7] in the Analysis

or System screen:

1 Enter the Analysis or System screen.

2 Select the On/Off button [F7].

3 Select the Pump button [F8].

4 Choose the desired function either with the Action buttons [F6-F8] or by

You can also access this function from the Settings button [F1] available in the

Analysis screen or the Control button [F1] in the System screen.

All pump settings can be entered in the Pump Settings screen. You can access

this screen by selecting the Settings button [F1] in the Analysis screen and then

choosing the pump. Commonly-used settings such as flow and solvent

composition can be set directly in the Analysis screen. The choices available

there depend on how many other modules are installed.

By opening the purge valve you can redirect the solvent flow from the pump

out through the valve exit instead of passing through the injection valve and

column. This purging process removes any undegassed or previously used

solvent within the pumping system.

selecting the On/Off buttons in the pop-up window. Uncheck the "to Standby

mode only" if you want to turn the pump on or off without going to standby

mode.

1200 Series Handheld Control Module Users's Guide

Table of Contents

Show Quick Links

Table of Contents

G1323a