Coexecution With Agilent Chemstation; Features - Agilent Technologies G1323B User Manual

1200 series handheld control module

Table of Contents

Coexecution with Agilent ChemStation

• Both user interfaces, the control module and the Agilent ChemStation, can

• Parameter entry is possible from both user interfaces. Parameters will be

• An Agilent ChemStation sequence can be stopped and aborted from the

• The Agilent ChemStation can generate data files from a control module

• If the control module starts an analysis, the Agilent ChemStation is the

In general, however, it is not recommended to run both the Agilent

ChemStation and the Control Module at the same time. Since the Agilent

ChemStation offers a wider variety of controls over the LC Series system and

handling it is much more comfortable it should be preferred over the Control

Module. Since problems in diagnosis and verification may occur in some

configurations the following restrictions apply:

1200 Series Handheld Control Module Users's Guide

be connected to a Agilent 1200 Series system at the same time.

updated on the other user interface within a few moments.

control module and vice versa.

method or sequence. In this case the pre-fix and file name counter in the

Single Sample Info section of the Agilent ChemStation must be enabled

(protocol mode only).

slave/monitor system.

Working with the Control Module

Table of Contents

Show Quick Links

Table of Contents

G1323a