Table of Contents
Advertisement
Advanced Microwave
Technologies
DVANTECH
5. Ensure that the L-Band input signal is being applied to the Tx Input connector.
6. Allow the unit to warm
(see TABLE 1
at page 14).
6
.4 USING THE SSPB SOFTWARE
The RS-232 and the RS-485 interfaces provide the serial communication between the user's
monitoring and control system and the micro-controller within a Up-Converter. The user may
employ any RS-232 terminal communications software (like Term95 or HyperTerminal) or the
RS-485 seri
al communication protocol.
6.4.1 U
RS-232 I
SING THE
Before using the RS-232 Interface, become thoroughly familiar with the items listed i
TABLE 11 at page 29 and
Operate the SSPB via the RS-232 Interface as follows:
1. Switch on the power station's circuit breaker to power
2
. Run any terminal program in the personal computer.
3. Use the following communication parame
- Bits per second: 19200
- Data Bits: 8
- Parity: None
- Stop bits: 1
- Flow Control: None
1. After running the program in the comp
Figure 4
at page 28 will be shown.
NO
TE:
The micro-controller within the SSPB determines automatically whether the
unit is functioning alone, in a 1
2.
If necessary, to change the status of the SSPB, use the commands listed in
TABLE 11 at page 29.
up for 30 minutes, ensuring that all electrical specifications are met
NTERFACE
TABLE 12
at page 31.
ters:
uter and pressing the <Enter> key a display similar to
:1 or 1:2 redundant system.
SSPBM-K100-BTE
up the SSPB.
n
Page 27
Advertisement
Table of Contents
