Table of Contents
Advertisement
Advanced Microwave
Technologies
DVANTECH
----------------------------------------------- WARNING ---------------------------------------------------
W
hen supplying power to this equipment, use the 3-pin connector provided to connect to a
grounded power outlet; also use a ground strap between the station's ground bus and the
ground screw located on unit. If power is supplied without grounding the equipment, there is a
risk of receiving a severe or fatal electric shock.
In
the context of this document any voltage that is lethal is viewed as 'High Voltage'. Therefore,
even prime power (198 to 264 V AC) is dangerous because prime power potentials have been
known to cause death or injury.
-----------------------------------------------
T
his equipment can not be repaired by the operator. DO NOT attempt to remove the
equipment cover or to disassemble internal components. Only qualified service technicians
should service this equipment. There are high-voltage parts in this equipment presenting a risk of
severe injury to untrained personnel. In addition, there is a risk of damage to precision
components.
-----------------------------------------------
A
LWAYS TERMINATE THE OUTPUT WAVEGUIDE OF THE UNIT WITH AN RF
LOAD CAPABLE OF DISSIPATING FULL CW RF POWER. SIMILARLY
TERMINATE THE INPUT TO AVOID THE POSSIBILITY OF THE UNIT BEING
DRIVEN BY STRAY LEAKAGE SIGNALS. Incorporate the termination prior to applying
prime power to the unit. This procedure prevents self-oscillation and irradiation of the local
environment. Even if a source is not connected to the unit you are working with, there are
situations when the unit can go into a self-induced mode and generate high levels of RF energy.
Destruction caused under excessive load voltage standing wave ratio (VSWR) will void the
warranty.
WARNING ---------------------------------------------------
WARNING ---------------------------------------------------
SSPBM-K100-BTE
Page 7
Advertisement
Table of Contents
