Operation - Farfisa EH9262CW series Technical Manual

INTERNAL STATIONS

OPERATION

Access the main menu
With the monitor in stand-by and no other videointercom turned ON
within the installation, access the menu by touching any active point of
the sensor wheel.
From the main menu the user can access all programming, set-up,
adjustments and activation sub-menu.
Access the "Favourite buttons" menu (direct
activation of functions)
Press any one of the six buttons on the side of the screen, will appear
the functions associated with each individual key (if programmed in
"Favourite buttons" on page 2.9).
The image below shows the menu "buttons" with the factory settings.
Empty
Empty
Silent
The keys can activate the programmed function only when the monitor
is turned ON.
How to display next/previous functions of a page
Sylvia Christina
Office John
Concierge Back
If on middle bottom screen are displayed 2 or more boxes it means
that the functions are present in several pages. Use the keys
or rotate the wheel sensor to move from one page to another.
Empty
Empty
Gate
Neal
Grandparents
OK
2.
11
(MT13 - En 2015)
Videointercom
Following an incoming call from the outside or by touching the key
" ", on the screen is displayed an image for about 30 seconds. By
touching the key " " once again, it is possible to communicate to
external stations for about 90 seconds.
To shut down the videointercom touch the key "
to expire.
The electrical lock can be operated by touching the key
the keys, without receiving a call, the user operates the electrical lock of
the last calling entrance.
With the videointercom image displayed, the user can adjust the audio/
video parameters or select other entrances (if any), by touching the side
keys.
Video settings (contrast, brightness and colour)
Disabling/enabling videointercom microphone
Ringtone disabling (see section "Ringtone disabling)
Adjusting the audio and ringtone volume (attention! New the
settings are permanently stored in the memory)
List of additional services available (video cameras, actuators,
etc.)
Operating the automatic gate or supplementary video camera
Ringtone disabling
The ringtone can be disabled instantly upon receiving an incoming call
by touching the key . At the next call, the ringtone will be enabled
automatically.
To permanently disable the ringtone you must access the "Favourite
buttons" and touch the key ; the symbol will flash to indicate that the
ringtone has been disabled and will keep ON flashing until the ringtone
will be reactivated again by the same procedure.
2
" or wait for the timer
; touching