Programming - Farfisa EH9262CW series Technical Manual

INTERNAL STATIONS

PROGRAMMING

To ensure correct operation of the videointercom, the latter must be
programmed by the installer; incorrect programming may compromise
the operation of the whole system. The main parameters to be set are
the following
User address (mandatory); this address identifies the videointercom
device within the installation. Enter a number from 001 to 200 taking
into consideration the following:
- the number of the apartment should not be equal to that of an another
apartment; if there are several internal stations connected in parallel
in the same apartment, they should have the same user address but
different room number (see the next section);
- it should match the address stored in the external push-button panel
and the door keeper exchanger, if any;
- it should be stored in the calling key and the contacts of another
device, if intercommunication between the two users is required.
Room number (mandatory in case of multiple devices in the same
apartment); identification address of a device inside the same
apartment (addresses from 000 to 009). The room number establishes
a hierarchy in the internal devices since the device with room address
0 (zero) will be the main device and all the other devices will be the
secondary ones. The different room number enables making/receiving
calls between devices installed within the same apartment selectively.
The external calls or calls from another apartment will make all
devices ringing, the first device that answers the call will activate the
conversation and switch OFF the ringer of the other devices. When
you receive a call from an external door station equipped with
camera, all the devices will ring, but only the main device (room
address 0 - zero) will display the camera image. The entrance can be
displayed from any of the other videointercom installed in the same
159
160
User address (example 160)
(MT13 - En 2015)
apartment by pressing the key "
turns ON the relative videointercom, while turning OFF the main
videointercom screen.
Intercommunication devices; names and addresses of other
devices that you intend to communicate with such as:
- users of other apartments; it allows to call them selectively (addresses
from 001 to 200);
- videointercoms in the same apartment; it allows to intercommunicate
with the equipment of other rooms in the same apartment (room
number from 000 to 009);
- door keeper exchangers (addresses from 201 to 210).
Entrances; names and addresses of external door stations (not
necessary in the case of a single door station) to enable the
videointercom to monitor these entrances separately and operate
the lock, if needed (addresses from 231 to 250).
Actuations; names and addresses of actuators for additional
services (additional locks, stair lights, etc.) that can be activated
directly from the videointercom (addresses from 211 to 220).
Favourite buttons; when the monitor is in stand-by, the 6 side keys
can be used to directly activate additional services that are used
more frequently (automatic gate, stair lights, intercommunicating
calls, calls to door keeper, etc.).
Warning: the addresses stored in the videointercom must
be the same of those programmed in the devices to enable.
159
160 160
000 001
Room addresses
2.
7
"; this key disables all buzzers,
160
002
2