Table of Contents
Advertisement
INTERNAL STATIONS
MENU DIAGRAM
Intercommunicatings List of intercommunication devices stored in the
Entrances
-
List of entrances present in the system.
Actuators List of
-
Ringtones - Pre-listening
door stations
and floor calls (doorbell).
Ma nte
i
nance
-
In this menu the user can modify parameters that are used more frequently and that do not
compromise system operation; to modify other parameters access the "Set
Intercommunicating -
intercommunicati
Entrances -
stations
in entrances list
Actuations Possibility to change the name and the
Language List and selection of languages available.
-
Audio -
Change sound and volume of keys and ringtone volume and duration
Video -
It enables adjusting brightness, colour and contrast of video image
Settings - This menu is reserved exclusively to qualified staff; therefore, it is protected by password.
Intercommunicating - Here the user can enter the names and addresses of intercommunication devices
or to modify the data stored previously; to manage these parameters, the user must know the user and
room addresses (if required).
Entrances - Here the user can enter the names and addresses of external door stations or to modify the
data stored previously; to manage these parameters, the user must know the addresses of door stations.
A tua io
c
previously; to manage these parameters, the user must know the addresses of actuators.
Installation wizard - This procedure enables simple setup of parameters that are essential for the
operation of the device. The procedure is enabled automatically at first power-ON or it can be run later
via this menu.
Favourite buttons - In this menu the user can assign direct functions to any of the 6 keys located to the
side of the screen; direct functions are assigned through factory setting only to the 2 keys on bottom
right (second door opening) and left (silent).
Default - It enables resetting the factory settings of the device; if there are any intercommunicating
devices, external door stations and actuators programmed, such entries will not be deleted.
Advanced - Procedures and information protected by password that can only be accesses by Aci Farfisa
technical service.
Show settings - List of all actual settings.
Back
About Software version of the device
-
Back
- Return to previous page.
Exit. Exit the main menu; the monitor shuts down
-
actuator
s present in the system
and assignment of
ringing melodies
Possibility to change the name, the
ng
calls
in intercommunicating list
Possibility to change the name, the
.
-
t ns - Here the user can enter the names and addresses of actuators or to modify the data stored
System - Here the user can set the specific parameters of the system.
User address - This is the address that enables the video intercom to receive the call coming
from external door stations from door keeper exchangers or other internal intercommunicating
stations. For further information refer to chapter "Programming".
Room - This is the address that enables identifying the intercommunicating devices installed in
the same apartment; therefore, devices that have the same user address, but installed in
different rooms. For further information refer to chapter "Programming".
Supplementary addresses - The additional addresses (maximum 10) are further addresses to
which the device should answer beside its own.
Forwarding A1 - Enables or disables redialing floor call (doorbell) to other devices installed in
the same apartment or running advanced functions.
Back
- Return to previous page.
- Return to previous page.
.
(MT13 - En 2015)
videointercom
.
to individual intercommunicatin calls,
tings
" menu.
melody
of ringtone and the
.
melody
of ringtone and the
sorting
in
actuations
list.
.
.
.
2.
10
g
calls
from
sorting
sorting
of calls from external
door
of
Hide quick links:
Advertisement
Chapters
Table of Contents
