Effects Parameters (Front Panel) - Dave Smith Instruments Sequential PROPHET X User Manual

Effects Parameters (Front Panel)

Turns effect 1 on or off. On stacked or split sounds, enable the
Effect 1:
button to adjust effects for Layer B.
edit layer b
Turns effect 2 on or off. On stacked or split sounds, enable the
Effect 2:
button to adjust effects for Layer B.
edit layer b
Selects the effect type.
Effect Type:
Toggles between effect 1 and effect 2 for editing.
Select 1/2:
—Sets the balance between the processed (wet) signal
Mix: 0...127
and unprocessed (dry) signal. Full left is completely dry. Full right is
completely wet.
—When a delay effect is chosen, this enables syncing of the
Sync: On, Off
timed delay repeats (feedback) to the arpeggiator, sequencer, or MIDI clock.
When
clk sync
Value
Whole
Half dot
Half
Quarter dot
Quarter
Quarter triplet
8th dot
8th
8th triplet
16th dot
16th
Maximum delay time is 1 second. The combination of longer synced delay
times with slower tempos can result in delay times that would be greater than 1
second. When that happens, the delay time is divided by 2 until it no longer exceeds
the 1 second limit. For example, if the BPM is set to 60 and Delay Time (Parameter 1)
is set to Half, the expected delay time would be 2 seconds. The actual delay time will
be 1 second (i.e. 2 seconds divided by 2).
60 Effects
is on, delay time (parameter 1) has the following values:
Delay Time
4 beats
3 beats
2 beats
1 1/2 beats
1 beat
1 1/3 beats
3/4 of 1 beat
1/2 of 1 beat
1/3 of 1 beat
3/8 of 1 beat
1/4 of 1 beat
Dave Smith Instruments