Tab 3 - Inst Loop - Dave Smith Instruments Sequential PROPHET X User Manual

TAB 3 - Inst Loop

XFade Rate Loop Mode
20
Regular
X FADE RATE LOOP MODE
Inst1 Tune Inst1 Misc
XFade Rate: 0...255
controls the length of the crossfade between the loop start and loop end.
Some sounds benefit from longer loops in order to smooth the transition
between these points.
Loop Mode: Regular, Pitched, Sync
in an instrument or sample (if a loop exists in the sample). In
mode, the loop plays continuously while a key is held. In
the loop becomes a pitch period calculated based on the assigned note of
the sample. You can change the size of this pitch period by pressing Soft
Key 4 (Inst1 Edit) and changing the
of of 1 indicates a single pitch period. In
in sync with the master clock BPM. This is useful for loops that consist
of rhythmic material that you wish to synchronize to the sequencer and
arpeggiator.
Edit Sample: On, Off
size or center, turning off
and play the sample in its original, unmodified state.
Sample Vel: On, Off
multi-sample switching on or off for the selected instrument. Turning
sample velocity off will cause the Prophet X to always play the sample
normally designated to have the greatest velocity. It will not switch
samples based on how hard you play, as it usually would.
20 Sample Playback
Edit Sample
EDIT SAMPLE
Inst1 Loop
—If is on for a sampled instrument, this
loop
—If you have edited a sample's start, end, or loop
edit sample
—Toggles velocity sensitivity and velocity-based
Sample Vel
SAMPLE VEL
Inst1 Edit
—Sets how the sustain loop behaves
setting. A
loop size
mode, the loop plays back
sync
will temporarily ignore the edits
Dave Smith Instruments
regular
mode,
pitched
setting
loop size