■ Mounting
D Mounting location
Select a location that provides easy access to the
remote controller for navigation safety, has good
ventilation and is not exposed to sea spray. The
remote controller should be at 90 degrees to your line
of sight when operating it.
NOTE: BE SURE to turn OFF [DC ISOLATE] on the
GM800 main unit when mounting the transceiver.
Adjust the display angle to be easy-to-read.
D Attaching the mounting plates
1. Attach the supplied rubber feet to the mounting
plate, if desired.
2. Attach the mounting plates using the supplied
hex head bolts (M6×15), flat and spring washers,
as shown below.
Hex head bolt (M6×15)
Spring washer
Flat washer
Mounting plate
CONNECTIONS AND INSTALLATION
D Mounting the remote controller
Mount the remote controller using the supplied
mounting bracket kit.
D Mounting the main unit
Hex head bolt (M6×50)
Spring washer
Flat washer
Flat washer
Spring washer
Nut (M6)
9
9
Drill 6 holes,
6 mm in
diameter.
82