Receiving And Transmitting; D Receiving; D Transmitting; Dsc Scan - Icom GM800 Instruction Manual

Mf/hf marine transceiver
Hide thumbs Also See for GM800:
Table of Contents

Advertisement

■ Receiving and toansmitting

D Receiving

1. Select a channel by rotating [CH/GRP], or
pushing the keypad keys. (p. 11)
2. When receiving a call, rotate [VOL] to adjust the
audio output level.
TIP:
When a call is received:
• The
icon is displayed.
• You can hear receive audio from the speaker.
• The S-meter displays the received signal strength.
D Toansmitting
1. Select a channel by rotating [CH/GRP] or pushing
the keypad keys. (p. 11)
2. Push [Ω] or [≈] to display "TX FREQ Monitor" in
the Software Key area.
3. Hold down [TX FREQ Monitor]
monitor the transmit frequency of the selected
channel.
• The transmit frequency is displayed and
NOTE: If the channel is busy, wait until it becomes
clear, or change to another channel.
4. Hold down [PTT] on the handset to transmit.
is displayed.
NOTE: If "SWR" is displayed during the transmission,
check your antenna system.
5. Speak into the microphone at your normal voice
level.
6. Release [PTT] to receive.
is displayed.

■ DSC scan

To receive a DSC call, such as an Individual call or a
Group call, push [D-SCAN] to enter the DSC watch
mode.
DSC watch mode
NOTE: Foo the Time-out Timeo (TOT) function
The TOT function inhibits continuous transmission
beyond a preset time period after the transmission
starts. 10 seconds before transmission is cut off, a
to temporarily
beep sounds to indicate the transmission will be cut
off. Release [PTT] once to end your transmission
and reset the timer. You cannot transmit for 10
blinks.
seconds after it is cut off.
IMPORTANT: To maximize the readability of your
transmitted signal, pause for a second after pushing
[PTT], and then hold the handset 5 to 10 cm from
your mouth and speak at your normal voice level.
NOTE: The following frequencies are always
automatically monitored with this transceiver.
2187.5, 4207.5, 6312.0, 8414.5, 12577.0, and
16804.5 kHz

BASIC OPERATION

[Ω]/[≈]
Software Keys
Software Keys
[CH/GRP]
[D-SCAN]
5
KEY PAD
[VOL]
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
12

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents