Preparation; Entering The Mmsi Code - Icom GM800 Instruction Manual

■ Entering the MMSI code

First, you must enter your 9 digit MMSI (Maritime
Mobile Service Identity: DSC self ID) code at power
ON.
You can perform this initial code entry ONLY
ONCE. After entry, only your dealer or distributor
can change it. If you have already entered your
MMSI code, these procedures are not necessary.
Example: Entering the MMSI code (123456789).
1. Hold down [ ] for 1 second to turn ON the
transceiver.
• Three short beeps sound.
• " Push [ENT] to Register Your MMSI" is displayed.
2. Push [ENT].
NOTE:
Push [CLR] to cancel the entry. In that case,
the transceiver displays "Push [ENT] to Register Your
MMSI" again.
3. Enter your 9 digit MMSI code.
4. After entering the 9th digit, push [ENT].
• The MMSI CONFIRMATION screen is displayed.
5. Reenter your MMSI code to confirm.
6. After entering the 9th digit, push [ENT].
• The MMSI code is registered.
NOTE:
When you successfully enter your MMSI code, the
following screen is displayed.
Push
+
Rotate
After that, the Main screen is displayed.
The registered MMSI code is displayed at the top of the
CH/GRP
Rotate screen.
to select
a character
CH/GRP
Innooraaton
L
+
Push
Rotate
CH/GRP
Push
Push

PREPARATION

: Rotate [CH/GRP] to select.
: Push [ENT] to enter or set.
: Push the keypad keys to enter a
digit or text.
3
Push
+
Rotate
CH/GRP
Rotate
to select
a character
CH/GRP
1
+
Push
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
8