Calibrator Status; Error Queue; Input Buffer; Remote Commands And Error Codes - Fluke 3130 User Manual

Calibrator Status

Error Queue

If an error occurs from invalid input or buffer overflow, its error code is sent to the error
queue. The error code can be read from the queue with the command FAULT?. The error
queue holds 15 error codes. When it is empty, FAULT? shows 0. The error queue is
cleared when power is reset or when the clear command *CLS is entered.

Input Buffer

The calibrator stores all received data in the input buffer. The buffer holds 250 characters
and they are processed on a first in, first out basis.

Remote Commands and Error Codes

This section shows and describes all of the remote commands that are accepted by the
Product.
Command
*CLS
*IDN?
*RST
Table 3. Common Commands
(Clear status.) Clears the error queue.
Identification query. Shows the manufacturer,
model number, and firmware revision level of the
Product.
Resets the Product to the power up state.
Portable Pressure Calibrator
Description
Remote Operation
33