Product Commands - Fluke 3130 User Manual

3130
Users Manual
Command
DAMP
DAMP?
DISPLAY
DISPLAY?
ERROR_LOOP
ERROR_LOOP?
ERROR_MODE
ERROR_MODE?
ERROR_PORT
ERROR_PORT?
FAULT?
FUNC
FUNC?
HART_ON
HART_OFF
HART?
HI_ERR
HI_ERR?
IO_STATE
IO_STATE?
LOCAL
LOCKOUT
LO_ERR
LO_ERR
MOTOR_ON
MOTOR_OFF
MOTOR?
OUT
OUT?
34
Table 4. Product Commands
Turns on or off Damp
Show if DAMP is on/off
Turns on or off the displays specified in the command
Shows which displays are on/off
Turns on or off loop power in percent error mode
Shows the current state of loop power in error mode
Turns on or off percent error mode
Shows if percent error mode is on or off
Set the pressure port for percent error mode
Shows the pressure port for percent error mode
Shows the most recent error code
Sets the display mode as specified in the command
Shows the current mode of the upper, middle, and lower display
Turns on the HART resistor
Turns off the HART resistor
Shows the current state of the HART resistor.
Sets the 100 % of span limit for percent error mode
Shows the 100 % of span limit for percent error mode
Set the Product mA state
Shows the Product mA state
Shows user to manual operation of the Product
Locks out the keypad of the Product in remote operation
Sets the 0 % of span limit for percent error mode
Shows the 0 % of span limit for percent error mode
Turns on the motor
Turns off the motor
Shows the current state of the HART resistor
Set the Product to output the requested current
Shows the value of the current being simulated
Description