Top-Level Menu
The top-level menu is shown in Figure 8. It has three levels.
•
MENU- Push the MENU softkey to get to the main menu. See the "Main Menu"
section.
•
[Active Display]- The active display is shown in the middle field on the top-level
and main menu. In Figure 8 the active display is the LOWER display. This menu
item lets you assign the ZERO key to one of the three display sections. Push the
softkey that corresponds to the display named on the menu bar to change the active
display. If the chosen display is a pressure range, then the ZERO key becomes active.
•
LIGHT- The Product has a backlight for low-light situations. To turn on or turn off
the backlight, push the LIGHT softkey on the main menu. The backlight cannot be
controlled by the serial interface.
Main Menu
To go to the main menu, push the MENU softkey from the top-level menu. From the
main menu, the submenus can be accessed. The main menus are:
•
Config- Display Configuration menu
•
% Error Main Menu
•
MinMax Menu
•
Contrast Main Menu
•
Lock Config Menu
•
Setups Main Menu
•
Save/Recall Menu
•
Auto Off Main Menu
•
Setups Main Menu
•
Display Main Menu
•
Damp Main Menu
•
HART Main Menu
•
Pump Limit Main Menu
Some of these menus are broken up into more submenus.
Figure 8. Top-Level Menu
Portable Pressure Calibrator
Product Menus
hbb009.eps
11