Charging The Battery; Using The Charger - infaco Electrocoup F3015 Original Instructions Manual

charging the battery

Using the charger

To charge your battery, plug in the charger in a well ventilated area which is free from inflammable
products and other sources of combustible materials. The area must be at a temperature between
10°C and 25°C and be sheltered from damp conditions.
1. Connect one end of the power cord
3. When powered on, the charger initialises:
Green LED + Red LED light
Charging the battery
It is strictly forbidden to charge the batteries when the temperature in the room is below 0°C
or higher than 40°C.
When charging, the battery must not be covered and not be close to a heat source.
1. Place the battery on channel 1
3. . Battery charge completion:
- Channel 1: Green LED on (not flashing).
The time needed to fully charge an 831B battery
is about one and a half hours.
10
to the charger.
for 2 seconds.
of the charger.
2. Connect the other end of the power cord
to the mains outlet.
4. When the LEDs turn off,
the charger is ready for use.
Voie 1
2. Once the battery is in place, the charger detects it
and begins charging:
- Channel 1: Green LED flashes quickly
throughout the charge.