Use; Half Opening; Controlled Or Pulse Mode; Battery Charge Level - infaco Electrocoup F3015 Original Instructions Manual

USE

When the device is running, always keep your hands away from the cutting head.

Half opening

The pruning shears are equipped with a half-opening switch which you can use to reduce blade
opening by approximately 50 %. The half opening position can be adjusted to your own liking (see
page 14).

CONTROLLED or PULSE mode

There is a choice of two operating modes:
- either the "CONTROLLED"/"PROPORTIONAL" mode (opening and closure depends on
how quickly the trigger is pressed).
- Or the "PULSE" mode (pressing or releasing the trigger once, closes and opens the blade
respectively at maximum speed).
1. To switch from one mode to the other,
off), the charge indicator flashes green.
2. Press the trigger to check the mode change..

Battery charge level

8
1. To move the blade to the half open position, press the half-opening
switch.
2. Press the trigger until the blade closes.
3. When it reopens, the blade will be in the half open position.
quickly
x6
The battery charge level is indicated by the 3 LEDs on the pruning shear
charge indicator. When the last LED flashes, the battery charge is less than
10%.
Battery flat state:
When the battery is completely flat,
the pruning shears stop. The power
supply LED flashing red quickly and the
3 charge indicator LEDs switch off. The
battery must be recharged when in this
state (see page 10).
flick the half-opening switch 6 times (3 on and 3