Recharging The Battery - infaco A3MV2-12V Original User Manual

Tying machine
Table of Contents

Advertisement

Recharging the battery

The battery has sufficient autonomy to complete between 7000 and 8000 ties.
If you are thinking of doing more than 8000 ties a day, we advise you to:
1.
Either recharge the battery for at least an hour during your lunch break to achieve
extra autonomy of approximately 3000 ties.
2.
Or buy the 2-battery option.
N.B. a few minutes before your battery is completely discharged, the A3MV2 may lose speed
or no longer cut the wire.
Charger
indicator light
= in charge
= loaded
Disconnect connector on the A3MV2
Connect plug on the charger to the 230 V 50 Hz supply in a well-ventilated room free of
inflammable products and sources of ignition.
Connect connector on the charger
The charger starts to work automatically as soon as the battery is connected.
A orange indicator light glows steady during the charging time. When the battery is fully
charged, the indicator light turns green and the charger supplies a holding charge.
If the indicator light on your charger does not light up, leave your battery connected and,
at the same time, disconnect the plug (230 V) from your charger and re-connect it until the
orange indicator lights light up.
For information, it takes about 5 hours to charge up the battery belt. Do not leave your
battery on charge for more than 15 hours.
2
1
3
3
from the battery
1
to connector on the battery
14
Battery
pack
2
.
2
.
A3MV2
13

Advertisement

Table of Contents
loading

Table of Contents